TankVault is in early access — we’re finishing the last pieces before launch.See Your Options

New Hampshire rules

Septic and Well Requirements for New Hampshire Home Sales

New Hampshire requires a septic evaluation at transfer, but only for developed waterfront property where part of the system sits within 250 feet of the reference line. Under RSA 485-A:39 the buyer, at the buyer's expense, must hire a licensed septic system evaluator before the transfer closes.

Free. No account needed.

Septic Rules When a New Hampshire Home Sells

Statewide rule
Who May Inspect
A New Hampshire licensed septic system evaluator performs the evaluation. If the system was never approved by NHDES under RSA 485-A:29, or its approval predates September 1, 1989, the buyer must also hire an NHDES-permitted septic system designer.
Report Rules
The evaluation must be completed before transfer; a seller's evaluation under 180 days old may be accepted in writing. If the system is failing, the evaluator notifies NHDES and the local health officer, and the buyer must replace it within 180 days.
County Programs
RSA 485-A:39 is the only transfer trigger, and it applies statewide to qualifying waterfront property, not to inland homes. Local health officers receive failure notifications and may impose additional requirements, and systems near water may also need a Shoreland permit.
Advanced Systems
Every system needs both an Approval for Construction and an Approval for Operation from NHDES before use, issued after an inspector confirms installation matched the approved plan. Advanced designs carry monitoring and maintenance conditions in the NHDES approval, not a statewide schedule.
Pump-Out Rules
No statewide pump-out interval. NHDES recommends regular pumping and maintenance; any fixed cycle would come from the system's approval conditions or a local ordinance.

Set and enforced by New Hampshire Department of Environmental Services (NHDES) - Subsurface Systems Bureau. Confirm the rule for a specific property with them or the county health office.

Private Well Rules When a New Hampshire Home Sells

Statewide rule

New Hampshire does not require a well water test at transfer — NHDES states there is no state testing requirement — but it does require two statutory written disclosures before a purchase contract is signed: the private water supply and septic disclosure under RSA 477:4-c and the radon and arsenic notice under RSA 477:4-a.

Who May Test
No statewide requirement, so no mandated sampler. NHDES directs buyers to order the "NH Well Water Test for Home Buyers" from an NHDES-accredited laboratory, which supplies bottles and instructions. Lenders and some town health or building codes impose their own requirements.
What Is Tested
No statewide mandatory list and no required flow or yield test. NHDES names radon and arsenic as the most common contaminants of concern in New Hampshire bedrock wells and recommends the home buyer panel, plus a stagnant-water sample for lead and copper, with retesting every three to five years.
Disclosure at Sale
Yes. RSA 477:4-c requires the seller to disclose, before the contract is signed, the private water supply's type, location, malfunctions, installation date, date of the most recent water test and any unsatisfactory result, plus septic details. RSA 477:4-a requires a separate buyer-acknowledged notice about radon and arsenic in well water.
Unused Wells
No statewide statute tying well abandonment to property transfer. Well construction and decommissioning are overseen by the NH Water Well Board and NHDES, and sealing should be done by a licensed well contractor. Confirm specifics with NHDES, as the Board's public FAQ does not address abandoned wells.
Distance From Septic
NHDES requires a 75-foot protective radius around a well serving a home of up to five bedrooms, applied to both the property boundary and the septic system including tank and leachfield. For larger systems the required distance rises with design sewage flow, up to roughly 400 feet.

Set and enforced by New Hampshire Department of Environmental Services (NHDES), Drinking Water and Groundwater Bureau / NH Water Well Board. Confirm the rule for a specific property with them or the county health office.

What a Septic Inspection CoversTank, distribution, pumps, drainfield, loading, records

A septic inspection is not part of a standard home inspection, and walking the yard with a probe is not an inspection. These are the parts an inspector is expected to open, look at and write up.

The Tank

Opened at the manhole, not just the inspection port. Sludge and scum measured, baffles or tees checked, effluent filter pulled and cleaned, walls and lid checked for cracks and leaks.

Distribution

Distribution box, drop boxes, diverter valves and the pipes between them, checked for level, roots, standing effluent and blockage.

Pumps and Controls

Pump tank, float settings, alarm test, control panel and run-time counters. On an advanced system, blowers, media and disinfection units too.

The Drainfield

Trenches, beds or drip lines walked for ponding, breakout, odor and soggy ground, plus grading and roof runoff that pushes water into the field.

Size and Loading

Permitted design flow in gallons per day or bedroom count, from the health department record, compared with how the house is actually being used and marketed.

The Paper Trail

Permits, as-built drawing, pump-out receipts, service contract, operator reports and any lab results. Missing records are a finding of their own.

What the Buyer’s Loan RequiresFHA, VA, USDA, conventional and 203(k)

State law decides what the inspection has to contain. The loan program decides whether the deal can close with what the inspection found. These rules are federal and apply in every state.

LoanWhen an Inspection Is RequiredWell DistancesWater TestingIf It Fails
FHANo septic inspection on every loan. One is required only if the appraiser sees evidence of failure, state or local law requires it, or the lender asks. A well water test is required in specific listed situations.4000.1 sets: well 10 ft from property line, 50 ft from septic tank, 100 ft from drainfield or seepage pit, 50 ft from non-watertight sewer lines. A July 2026 FHA waiver lets existing homes use local distances instead if water testing is documented.Required for new construction, when the appraiser reports a well problem, when water is known unsafe, near landfills or farms, or when well-to-septic is under 100 ft. A disinterested third party samples; local or EPA limits apply; report under 180 days old at disbursement.The system must meet Minimum Property Requirements before FHA will insure. Health and safety deficiencies are repaired before closing. A repair completion escrow is allowed only when work genuinely cannot be finished first, such as weather delays.
VANo septic inspection on every loan. The appraiser looks first; a licensed inspection or local health authority approval is required only if problems show, soil conditions are known to be poor, or state, local, or lender rules require it.Not specified by the program. VA Chapter 12 sets no well-to-septic or well-to-line distances and defers to the local or state health authority with jurisdiction. Secondary lender guides sometimes quote FHA's numbers, but VA itself does not.Required when the home has a private well. A disinterested third party must collect and test the sample; the borrower may not. Local health authority standards apply, then state, then EPA. Lenders commonly treat the certification as valid for 90 days; confirm the window with the lender on the file.A septic or well failure is a defective condition, so the home is unacceptable until repaired and further damage is ruled out. Repairs are generally completed before closing; veterans may request a VA waiver of repair requirements in limited cases.
USDA GuaranteedStrictest of the five. A septic evaluation is required on every home with an individual system, by a HUD roster appraiser, health authority, licensed septic professional, or qualified home inspector. A water test is required on every well property.USDA adopts HUD Handbook 4000.1 distances (10 ft to property line, 50 ft to septic tank, 100 ft to drainfield) or the actual distances accepted by the state or local health authority. The septic must sit entirely on the subject property.Required on all wells, performed by the local health authority or a state-certified lab. State or local standards apply, or EPA maximum contaminant levels if none exist. The water analysis report must be no more than 150 days old at closing.The system must be repaired so the home is decent, safe, and sanitary. A post-closing repair escrow is possible only if the work does not affect livability, costs 10 percent or less of the loan, is under contract, fully funded, and done within 180 days.
ConventionalMost permissive. Neither agency requires a septic inspection or water test on every loan. One is ordered only when the appraiser notes a problem, a nearby environmental hazard raises concern, or state, local, or lender rules require it.Not specified by the program. Fannie Mae and Freddie Mac set no separation distances and instead require that utilities meet community standards, which in practice means the local health authority's rules govern.Not routinely required. Fannie Mae calls a well certification sound judgment when the lender has reason to believe water may be contaminated, such as a well near a hazardous waste site. No contaminant list or validity period is published.The lender decides whether the home is adequate security and what inspections are needed. Appraisals are typically made subject to repair or professional inspection, with evidence of corrective action kept in the loan file before closing.
FHA 203(k)Same triggers as standard FHA, with one key difference: a known bad system does not have to be fixed by the seller first. Repairing or replacing a well or septic system is an eligible improvement that the loan itself can finance.Same FHA Handbook 4000.1 distances apply (10 ft to property line, 50 ft to septic tank, 100 ft to drainfield). New or replacement systems installed with loan funds must meet local permitting as built.Same as standard FHA: testing in the listed trigger situations, by a disinterested third party, against local health authority standards or EPA limits, with the report no more than 180 days old at disbursement.This is the real advantage. Repair or replacement costs are escrowed at closing and the work is done afterward, so the deal does not die on a failed system. Limited 203(k) caps total rehabilitation at 75,000 dollars; Standard 203(k) has no such cap.

Loan rules change and lenders add requirements of their own. Confirm with the lender on the file before you tell a client what is needed.

A Timeline That Protects the Closing DateSix steps, from listing to closing

Nearly every septic delay comes from the same place: the inspection was ordered late, and the report, the repair permit or the health department review ran past the contract date.

  1. 1

    Before You List

    Pull the permit and service history from the health department. A seller who knows what a buyer’s inspector will find can fix it or price it instead of renegotiating against a deadline.

  2. 2

    Day One of Due Diligence

    Order the inspection. Not day seven. In several states the inspector has up to ten business days to deliver the written report, and that clock runs inside your contingency.

  3. 3

    Inspection Day

    Power on, water on, lids reachable. Many inspectors want the tank pumped so the walls and baffles can be seen, which means booking the pumper the same day.

  4. 4

    When the Report Lands

    Read the parts that were not inspected and the reasons given. That list is usually where the next surprise is hiding.

  5. 5

    Repairs and Permits

    A repair or replacement normally needs a health department permit, and sometimes a soil evaluation. Build the review time into the extension, not just the contractor’s schedule.

  6. 6

    Before Closing

    Hand the operating permit, manual, service contract and maintenance log to the buyer, and make sure an advanced system has a licensed operator from day one.

What to Collect From the SellerEight documents to ask for at listing

Ask at listing. Every one of these is a document a lender, inspector or health department may ask for later.

  • Construction and Operating Permit. Shows the permitted flow, the bedroom count the system was approved for, and any ongoing conditions.
  • As-Built Drawing. Locates the tank, distribution box and field. Without it the inspection starts with a search.
  • Pump-Out Receipts. Five years where the county sets a pumping interval, three years everywhere else.
  • Service Contract. Required for advanced and aerobic systems in most states, and often required to be in force at transfer.
  • Operator Service Reports. The last two years, including anything filed with the health department.
  • Lab and Sampling Results. Where the permit requires sampling, or the system discharges to a stream or ditch.
  • Well Records. Well completion report, depth, the most recent water test, and any treatment equipment.
  • Repair Permits and Invoices. Any work on the tank, pump, field, control panel or well.

Homeowners keep all of this free in TankVault, and their septic company keeps it current. See the homeowner app.

Questions Agents Ask

Can a home inspector inspect the septic system?

It depends on the state. A growing number of states allow septic inspections only from someone holding an onsite sewage license, such as an operator, installer or soil evaluator, and an inspection by the wrong person may not satisfy the lender or the contract.

How long is a septic inspection good for?

There is rarely a date written into law, but lenders and buyers commonly treat an inspection older than six to twelve months as stale, and some states require the inspection to fall inside a set window before transfer.

Who pays for the septic inspection?

It is negotiable in nearly every state and the purchase contract decides. Sellers increasingly pay for an inspection before listing so the findings are theirs to handle rather than a renegotiation tool for the buyer.

Can you close on a house with a failing septic system?

On a government-backed loan, usually not until repairs are finished and verified. Conventional financing has more room, but the appraiser can still call out the condition and the lender can require it fixed before closing.

Does the septic permit transfer to the buyer?

In most states the operating permit runs with the property rather than the owner, and the upkeep duties travel with it. Some states and counties make the new owner file or register within a set number of days, and an advanced system usually needs a licensed operator from day one.

Why does the inspection report not say pass or fail?

Several states now forbid pass or fail wording and require the inspector to describe the condition of each part and what any problem means instead. It reads as less decisive and it is far more useful in a negotiation.

Does the well have to be tested when the house sells?

In most states only when the buyer, the contract or the loan asks for it. A handful of states require a test at transfer, and FHA, VA and USDA loans require one on any home served by a private well.

Where This Comes From8 sources for New Hampshire

General information for real estate professionals, not legal advice. New Hampshire rules change, and counties add their own, so confirm the requirement for a specific property with the agency above or the county health office.

Need Someone to Do the Work in New Hampshire?

Search septic companies by county, with phone numbers and websites. Free, no account.

Find a New Hampshire Septic CompanySee Another State